Brass FH Carb

#1 10-23-2004, 03:16 PM

Hello. I have a slant fin Briggs FH with a potmetal carb. I have located an original brass carb. My question is will the brass carb bolt right in place were the potmetal carb was? I don't think that they changed casting, did they? THANKS

#2 10-23-2004, 03:29 PM

Stevie, the bolt pattern on those carbs is differant. Depending on your ser# they did make slant fin FH engines with pot metal carbs. Should be between 26438 and 29705.

Similar Threads Chosen at Random
Thread	Thread Starter	F o r u m	Replies	Last Post
Briggs F series Brass Carb	K.Watkins	Small Air Cooled Gasoline Engines	15	06-11-2006 01:42 PM
Repro Brass Carb	OldironJeff	Antique Gas Engine Discussion	5	02-07-2006 12:53 AM
MYSTERY...Brass carb?	Alex	Antique Engine Archives	2	03-14-2004 09:58 AM
KINGSTON BRASS CARB	SONNY L	Antique Engine Archives	2	10-18-2003 02:02 AM
Lunkenheimer Brass Carb	tim	Antique Engine Archives	4	12-22-2002 06:11 PM

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Brass FH Carb

Hello. I have a slant fin Briggs FH with a potmetal carb. I have located an original brass carb. My...