|
|
|
|
|||||||
| Machine Shop and Tool Talk Shop Equipment, fabrication, repairs, how to fix it, which tool to use for the job. Machinist shop talk, straight to the point. |
|
Clausing 12" lathe "clutching mechanism"I'm looking for a blown up view of the clutching mechanism for a 12" swing variable speed clausing...this thread has 3 replies and has been viewed 1099 times
|
 |
|
|
Thread Tools | Display Modes |
|
#1
03-16-2009, 01:34 PM
|
|||
|
|||
Clausing 12" lathe "clutching mechanism"
I'm looking for a blown up view of the clutching mechanism for a 12" swing variable speed clausing lathe. "red C".Mod#5914
|
| Sponsored Links |
|
#2
03-16-2009, 05:28 PM
|
|||
|
|||
Re: Clausing 12" lathe "clutching mechanism"
I'll ask our machine repair people and see if they have any documentation on your lathe. We use a few Clausings here and they may have a lead if not the service manual.
Judd
|
The Following User Says Thank You to Judd Rogers:
|
||
|
#3
03-16-2009, 07:04 PM
|
|||
|
|||
|
Re: Clausing 12" lathe "clutching mechanism"
Quote:
Service Center, Goshen Indiana 811 Eisenhower Drive South Goshen, IN 46526 Phone: 800-535-6553 FAX: 574-533-0403 They are very helpful. Jim
|
The Following User Says Thank You to Jim Tremble:
|
||
|
#4
03-16-2009, 08:49 PM
|
|||
|
|||
|
Re: Clausing 12" lathe "clutching mechanism"
I second calling the Clausing people, they were able to help me with a manual for my 1944 12'' lathe and also told me most parts were available as well. Also keep them in mind for the Atlas lathes, I asked about split nuts for my Atlas 610, again no problems.
|
The Following User Says Thank You to curt dewitt:
|
||
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads Chosen at Random
|
||||
| Thread | Thread Starter | F o r u m | Replies | Last Post |
| Union Pacific RailFest 2007- "844" & "3977" | Robert M | Stationary Steam & Traction Engines | 18 | 10-29-2007 09:05 PM |
| Identity of diesel with "RMC" & "Chromidum" logos? | Jonathan B | Vintage Diesel Engines | 0 | 06-26-2005 05:06 AM |
| Are "S" leads the same as "T" on a 12 lead Genset? | Sean Mahannah | Generators & Motors General Discussion | 1 | 08-28-2004 06:05 AM |
| Fairbanks "Jack of all Trades" "T" Ser# List??? | Shane Ball | Antique Engine Archives | 1 | 07-29-2003 10:37 PM |
Linear Mode
