Ford engine overhaul gasket sets

aad · #1 07-20-2009, 07:30 AM

I have several nos ford engine overhaul gasket sets
The ford part number is CODZ=6008-c
according to my ford mechanic this fits an industrial engine from the sixties
Can anyone tell me which( 6 cyl inline) engine
Thanks

K D Redd · #2 07-20-2009, 09:10 AM

Ford in-line sixs of the sixties were 223 CID in it's own block. The small Ford six of 144,170,230 and 250 CID and the big Ford six in 240 and 300 CID. I assume it is one of these. Most likely the 240 or 300. If you have one set open, is there a gasket that would fit an intake manifold. If so that would eliminate the little Ford six as the intake was intergral to the head.

Kent

Richard W. · #3 07-20-2009, 10:12 PM

Didn't they stop making the 223 in 1964?

Richard

aad · #4 07-21-2009, 09:53 AM

There are no intake or exhaust gaskets in the set
Just a head gasket,fuelpump,valvecover,2 single circular,for the rest rubber gaskets some rope and a seal

Similar Threads Chosen at Random
Thread	Thread Starter	F o r u m	Replies	Last Post
Me Again! (Maytag engine overhaul)	blake in spokane	Maytag Engine Collectibles	1	12-23-2008 11:50 AM
MM gasket sets	Mike Rohrer	Antique Tractors - Old Iron Lugs, Cleats and Tracks	3	03-16-2007 05:46 PM
Lister and Petter gasket sets	quickies	Vintage Diesel Engines	0	10-18-2006 10:59 AM
PERMATEX vs. paper gasket vs. other gasket material	MarkP	Small Air Cooled Gasoline Engines	1	04-19-2006 09:18 AM
engine generator sets	Elliott Bayly	Antique Engine Archives	0	12-11-2000 05:45 PM

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Ford engine overhaul gasket sets

I have several nos ford engine overhaul gasket sets The ford part number is CODZ=6008-c according...