|
|
|
|||||||
| Welding Shop Welder generators, equipment, weld practice, techniques, troubles and solutions. See our TERMS of SERVICE prior to reading! |
|
Quick Question;I have a National Cylinder Gas Co. welding generator which is powered by an Onan CCK. There is a...this thread has 0 replies and has been viewed 587 times
|
 |
|
|
Thread Tools | Display Modes |
|
#1
02-22-2010, 10:42 PM
|
||||
|
||||
Quick Question;
I have a National Cylinder Gas Co. welding generator which is powered by an Onan CCK. There is a crankcase vent on top of the case that has some sort of valve inserted in it. There is a rubber piece that slips over that and goes on top of the carb. That piece is torn. Someone on here told me a part number for this piece that I could order through Cummins. Could I have that part number again, please?
Also, I was told that this valve needs cleaning from time to time. How can I assure myself that it is operating correctly after cleaning? Thanks! 
|
| Sponsored Links |
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads Chosen at Random
|
||||
| Thread | Thread Starter | F o r u m | Replies | Last Post |
| quick question | David Scott | Antique Gas Engine Discussion | 0 | 10-31-2009 10:38 AM |
| Quick question - weight of a 1.5 hp New Sattley? | Rex Dart | Antique Gas Engine Discussion | 2 | 03-21-2008 08:53 PM |
| Quick question on HP of Large Fairbanks | Dustin D Ehli | Antique Gas Engine Discussion | 2 | 02-05-2008 08:13 PM |
| Quick Case Question | Erik "Ned" Mars | Stationary Steam & Traction Engines | 1 | 07-27-2007 06:48 PM |
| Quick JD Question | Jim Thistle | Antique Engine Archives | 8 | 08-08-2002 11:34 PM |
Linear Mode
