|
|
|
|
|||||||
| Antique Engine Archives All archived posts from 1999 to 2004 when SmokStak was on EnginAds. This is a read-only board. |
|
Head Removal Le Roi UprightI posted a message a few weeks ago on a stuck exhaust valve in my Le Roi upright with good...this thread has 0 replies and has been viewed 480 times
|
|
|
Thread Tools | Display Modes |
|
#1
08-06-2003, 07:57 AM
|
|||
|
|||
Head Removal Le Roi Upright
I posted a message a few weeks ago on a stuck exhaust valve in my Le Roi upright with good feedback. Since then I have been successful in removing all of the head bolts inside of the hopper without breaking a stud. Now I am trying to remove the head/hopper (they are one piece), but it is being stubborn. There are 13 studs that hold it in place so there is not much wiggle-room. There are four tapped holes at the base of the head. I am wondering if these are supposed to be used along with a block and tackle to pull the head. Any help or suggestions would be much appreciated.
Bruce in PA |
| Sponsored Links |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads Chosen at Random
|
||||
| Thread | Thread Starter | F o r u m | Replies | Last Post |
| IHC LB engine head removal | Gerry Magnan | Antique Gas Engine Discussion | 4 | 10-30-2007 11:56 PM |
| Ihc LB head removal | Jas L | Antique Gas Engine Discussion | 3 | 05-21-2006 01:24 AM |
| 1.5 HP LB govenor linkage removal from crankcase to head ?? | Dale | Antique Gas Engine Discussion | 1 | 03-30-2005 07:25 PM |
| Le Roi Upright | Paul Voss | Antique Engine Archives | 1 | 09-01-2003 06:48 PM |
| C+H+E or E+C+H Upright | Kevin Stone | Antique Engine Archives | 0 | 09-13-2000 07:40 PM |
Linear Mode
