![]() |
|
|
Wisconsin Engines Single cylinder up to V4 engines. |
![]() |
Wisconsin VH4D Charging Problemthis thread has 2 replies and has been viewed 641 times
|
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hello
New here and have a VH4D, it appears to be a 1980. Motor runs well, but not charging, (25 amp stator) would like to convert to a single regulator/rectifier, seems originals are not available . Can anyone help with a conversion reg/rectifier part number, and how to?. Where is a good source of tune up and maintenance parts. Also does anyone have used shroud parts? looking for 1&3 lower shroud coil mounts to, and back shroud opposite flywheel, mine are quite rusted. Thanks in advance |
Sponsored Links |
#2
|
|||
|
|||
![]()
Just went through the same exercise on my VH4D. Had the old 3 wire stator and separate rectifier/regulator setup, everything was junk. Updated to P/N YB84 two wire stator and Kohler regulator. $14 for the regulator (either Amazon or Ebay) and $105 shipped for the stator from BW welding parts in Phoenix. Much simpler setup and works very well.
|
#3
|
|||
|
|||
![]()
email sent re: shrouds
|
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | F o r u m | Replies | Last Post |
Strange Points Related Problem With a VH4D | tima | Wisconsin Engines | 15 | 08-26-2018 08:41:15 AM |
VH4D Wisconsin Help!! | Firedog413 | Wisconsin Engines | 5 | 10-08-2015 05:56:29 PM |
Wisconsin VH4D overheating problem | mchunt | Wisconsin Engines | 6 | 06-16-2010 11:36:16 AM |
Rebuilt VH4D backfire problem. | tools | Wisconsin Engines | 11 | 06-14-2010 12:44:07 AM |
VH4D Wisconsin | Richard F | Wisconsin Engines | 3 | 05-12-2008 12:51:19 PM |