Antique Engines and Old Iron
[Home] - [HELP] - [Forums] - [Library] - [Photo Gallery] - [Groups] - [Classified Ads] - [Subscribe] - [Links] - [Books] - [Sponsors] -

Go Back   SmokStak > SmokStak® Antique Engine Community > Small Air Cooled Gasoline Engines > Wisconsin Engines
Forgot Password? Join Us!

Notices

Wisconsin Engines Single cylinder up to V4 engines.

Wisconsin Engines

Wisconsin has Backfire in carb


this thread has 7 replies and has been viewed 256 times

Reply
 
Thread Tools Display Modes
  #1  
Old 02-11-2019, 03:51:07 PM
Denny63 Denny63 is offline
Registered
 
Join Date: Dec 2018
Location: Elkhorn, Wisconsin
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
Default Wisconsin has Backfire in carb

57 AENDL new coil, points and condenser. Check ed timing TDC and x Mark spot on. Great spark hard to start. Will backfire through carb. Tried multiple carb adj. Will only start (when it starts)only run for a few seconds. Like its fuel starved. Pull plug it's slightly damp. Compression 80psi and I put air in the cylinder at DTC no leaks in intake or exhaust. There plenty of gas in the carb the air cleaner housing leaking a little and it's premium. Could an intake valve be sticking on this? Driving me nuts! Any ideas? Thanks.
Reply With Quote
Sponsored Links
  #2  
Old 02-11-2019, 05:54:04 PM
K-Tron K-Tron is offline
Registered-III
 
Join Date: Sep 2010
Location: Huntington, NY
Posts: 1,767
Thanks: 840
Thanked 867 Times in 603 Posts
Default Re: Wisconsin has Backfire in carb

Welcome to smokstak. Your engine will certainly run on 80psi of compression. If it is backfiring, either the valve seats are corroded, the valves are dirty, the valve lash is way out, or the timing is off. The X might be aligned when looking through the timing plug, but if the impulse of the magneto was not just ready to snap when the gears were lined up, the timing is still off. I make sure to clean, lap and adjust the valve lash on every new old Wisconsin engine I pick up before attempting to run it. I also take this opportunity to pull the oil pan and flush out fifty plus years of sludge and test the oil pump, before running the engine.

Chris
Reply With Quote
  #3  
Old 02-11-2019, 06:37:59 PM
Gene Williams Gene Williams is offline
Subscriber
 
Join Date: Jan 2007
Location: Piedmont, South Dakota
Posts: 606
Thanks: 3,435
Thanked 468 Times in 263 Posts
Default Re: Wisconsin has Backfire in carb

Sometimes on tractor engines the valve springs can become weak and not allow the valve to close fast enough when running causing back firing. I am not really sure this is your engines trouble because it doesn't start and stay running too well. K-Tron has some good thoughts also.

Gene williams
Reply With Quote
  #4  
Old 02-11-2019, 11:59:04 PM
gdstew gdstew is offline
Registered-II
 
Join Date: Jan 2015
Location: New Philadelphia, Ohio, USA
Posts: 863
Thanks: 229
Thanked 468 Times in 310 Posts
Default Re: Wisconsin has Backfire in carb

Possibly not timed on the compression stroke??????
Reply With Quote
  #5  
Old 02-12-2019, 05:51:17 PM
Denny63 Denny63 is offline
Registered
 
Join Date: Dec 2018
Location: Elkhorn, Wisconsin
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
Default Re: Wisconsin has Backfire in carb

Thanks guys. I'll double check the mag snap to make sure it correct. I've owned this for 20 years. It just been sitting because of the starting issue.
Reply With Quote
  #6  
Old 02-12-2019, 06:31:05 PM
John Campbell John Campbell is offline
Registered-I
 
Join Date: May 2010
Location: Tonopah, Nevada U.S.A.
Posts: 18
Thanks: 4
Thanked 44 Times in 6 Posts
Default Re: Wisconsin has Backfire in carb

Could someone have crossed a couple of wires. I have found, it doesn't take much out of time for an engine not to run. Most likely something simple. Good luck. John
Reply With Quote
  #7  
Old 02-12-2019, 06:47:04 PM
tew45 tew45 is offline
Registered
 
Join Date: Apr 2015
Location: Van Alstyne, Texas, USA
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
Default Re: Wisconsin has Backfire in carb

usually if the backfire is through the carburetor it is running too lean and through the exhaust too rich. Just a thought!
Reply With Quote
  #8  
Old 02-12-2019, 08:16:44 PM
CharlieB CharlieB is offline
Registered-I
 
Join Date: Dec 2014
Location: Severn, Maryland, USA
Posts: 304
Thanks: 26
Thanked 139 Times in 108 Posts
Default Re: Wisconsin has Backfire in carb

Fuel mixture too lean.
Check the throttle shaft for wear. If it wobbles, air is getting in and fouling up the air/fuel ratio. A bad carb to intake gasket will do the same thing. (If the carb hasn't been rebuilt since "57, maybe now would be a good time ??)
Reply With Quote
Reply

Bookmarks


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

F o r u m Jump

Similar Threads Chosen at Random
Thread Thread Starter F o r u m Replies Last Post
Wisconsin TJD carb wminmi Wisconsin Engines 1 10-18-2014 12:33:52 PM
need help..backfire out of carb: Wisc BKND johnnyrock70 Wisconsin Engines 6 01-26-2013 02:05:23 PM
Wisconsin BKN & AKN carb and mag? tmessenger Wisconsin Engines 4 05-26-2012 06:49:47 PM
Wisconsin AKN ODD CARB....HElP!!! Montana Outfitters Wisconsin Engines 1 01-14-2012 05:38:33 PM
Wisconsin THD CARB HELP.... madmowerz Wisconsin Engines 2 12-20-2011 10:10:40 AM


Use "Ctrl" mouse wheel to change screen size.
All times are GMT -4. The time now is 08:07:55 AM.

Smokstak and Enginads site search!


All use is subject to our TERMS OF SERVICE
SMOKSTAK® is a Registered Trade Mark - A Community of Antique Engine Enthusiasts
Copyright © 2000 - 2016 by Harry Matthews P.O. Box 5612 - Sarasota, FL 34277