Generators and Motors
[Home] - [HELP] - [Forums] - [Library] - [Photo Gallery] - [Groups] - [Classified Ads] - [Subscribe] - [Links] - [Books] - [Sponsors] -

Go Back   SmokStak > SmokStak® Vintage Electrical Equipment > Generators & Motors General Discussion > Onan Generators
Forgot Password? Join Us!

Notices

Onan Generators Restoring, operating and maintaining vintage Onan generators.

Onan Generators

Onan MDKD 6.5 overheaded and shut down


this thread has 6 replies and has been viewed 228 times

Reply
 
Thread Tools Display Modes
  #1  
Old 04-12-2017, 02:23:16 AM
Yobbo Yobbo is offline
Registered
 
Join Date: Apr 2017
Location: Capalaba, Queensland, Australia
Posts: 3
Thanks: 4
Thanked 0 Times in 0 Posts
Default Onan MDKD 6.5 overheaded and shut down

Hello, just wondering if there is anyone who could help with some Onan advise

I have a 6.5 MDKD-P (I'm located in Australia) in my boat, the other night it overheated and shut down, I pulled up the floor to the engine room and could smell a burning rubber smell and a small amount of coolant on the engine room floor. I waited about 1 hour pressed the reset switch and it started up straight away but with a loud squeeling sound like the belt was slipping, I also checked that it was pumping water out of the exhaust which told me the raw water side is fine ( I also checked the raw water impeller just to be sure). The next morning it started up and ran fine but I could hear what sounded like a bearing noise coming from either the cooling pump or the alternator on the actual engine. so here are my questions

Q What engine does my MDKD use?
Is it a Kubota D950?
If it is a Kubota D950 engine does it use any special Onan circulation / water pump and alternator? or just the standard Kubota one?

Thank you very much, cheers Ian
Reply With Quote
Sponsored Links
  #2  
Old 04-12-2017, 04:06:24 AM
Yobbo Yobbo is offline
Registered
 
Join Date: Apr 2017
Location: Capalaba, Queensland, Australia
Posts: 3
Thanks: 4
Thanked 0 Times in 0 Posts
Default Re: Onan MDKD 6.5 overheaded and shut down

The serial number is E890240974 , cheers Ian
Reply With Quote
  #3  
Old 04-12-2017, 06:04:43 AM
RETCPO RETCPO is offline
Registered-II
 
Join Date: Sep 2010
Location: Hampton, VA USA
Posts: 490
Thanks: 172
Thanked 278 Times in 189 Posts
Default Re: Onan MDKD 6.5 overheaded and shut down

Down load your manuals from http://www.twinslan.net/~n0nas/manuals/onan/
981-0502
981-0600
Reply With Quote
The Following 3 Users Say Thank You to RETCPO For This Post:
  #4  
Old 04-12-2017, 03:44:23 PM
BigBlockChev's Avatar
BigBlockChev BigBlockChev is offline
Subscriber
 
Join Date: Jan 2007
Location: Coquitlam, BC, Canada
Posts: 1,611
Thanks: 276
Thanked 1,090 Times in 666 Posts
Default Re: Onan MDKD 6.5 overheaded and shut down

I would pull the belt off and see whether it is the water pump or the alternator. I have seen both screw up. I dont believe it is anything special for either one just regular Kubota parts. Cheers Dan
__________________
It's always something simple.
One test is worth a thousand guesses.
If some is good and more is better then too much is just enough
Reply With Quote
The Following 2 Users Say Thank You to BigBlockChev For This Post:
  #5  
Old 04-12-2017, 06:50:59 PM
TLB01 TLB01 is offline
Subscriber
 
Join Date: Feb 2017
Location: Seabeck, Washington
Posts: 161
Thanks: 11
Thanked 72 Times in 46 Posts
Default Re: Onan MDKD 6.5 overheaded and shut down

Probably the water pump. D650-D950 are the same pump. If it was the little dynamo the machine would have overheated only after the belt snapped and you would have smelled that long before then. Might also want to see if anything blocked the circulation water in the heat exchanger. Gunk or whatever. The MDKC I am working on was pretty disgusting in all the coolant system routing. Doubt it even circulated.
Reply With Quote
The Following 2 Users Say Thank You to TLB01 For This Post:
  #6  
Old 04-12-2017, 09:35:06 PM
Yobbo Yobbo is offline
Registered
 
Join Date: Apr 2017
Location: Capalaba, Queensland, Australia
Posts: 3
Thanks: 4
Thanked 0 Times in 0 Posts
Default Re: Onan MDKD 6.5 overheaded and shut down

Thank you for the tips, it's in a sound shield and under the flooring right in front of the starboard engine, it's a real pain to get to it, especially someone my size , how can I tell what model of engine it is? Cheers Ian
Reply With Quote
  #7  
Old 04-12-2017, 09:56:00 PM
TLB01 TLB01 is offline
Subscriber
 
Join Date: Feb 2017
Location: Seabeck, Washington
Posts: 161
Thanks: 11
Thanked 72 Times in 46 Posts
Default Re: Onan MDKD 6.5 overheaded and shut down

There should be a CC displacement cast onto the block somewhere. In the case of mine it was below the head, back end of the engine behind the raw water pump. That should get you in the ball park. For example mine is a 675cc engine so its a D650. A D950 has a displacement of 927cc. Otherwise, all those engines look the same. Its like looking at a small block chevy engine and having to guess (if you could not see the balancers anyway). All those SETS look the same. There is a parts set near by that is a 8.0 and looks just like my 4.0. Other than finding the model/serial plate, its hard to tell them apart. Good thing the water pump and the dynamo should be universal for all MDKs. On the land based sets, there are totally different set ups, even if using the same engines.

Last edited by TLB01; 04-12-2017 at 10:10:19 PM.
Reply With Quote
The Following User Says Thank You to TLB01 For This Post:
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

F o r u m Jump

Similar Threads Chosen at Random
Thread Thread Starter F o r u m Replies Last Post
Onan MDKD 7.5 TLB01 Onan Generators 12 03-16-2017 05:48:23 PM
Onan MDKD Repairs Viking66 Onan Generators 14 03-11-2016 10:24:33 AM
Onan 8 MDKD Straitsman Onan Generators 9 04-22-2015 03:12:20 PM
ONAN MDKD-1R 1B Manual mainship Onan Generators 5 08-28-2012 09:05:29 AM
Help! Can't start Onan 8k MDKD jeffgregory Onan Generators 10 09-17-2006 09:09:26 AM


Use "Ctrl" mouse wheel to change screen size.
All times are GMT -4. The time now is 03:21:38 AM.

Smokstak and Enginads site search!


All use is subject to our TERMS OF SERVICE
SMOKSTAK® is a Registered Trade Mark - A Community of Antique Engine Enthusiasts
Copyright © 2000 - 2016 by Harry Matthews P.O. Box 5612 - Sarasota, FL 34277