![]() |
|
|
Antique Marine Engines and Outboard Motors Discussion on old marine engines, naptha, gas, oil or steam and vintage outboard motors. |
![]() |
Help with Overcenter PTO Clutch (Rockford)this thread has 0 replies and has been viewed 643 times
|
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
If this is in the wrong thread please tell me so it can be moved. General forum searches yielded no results.
Searching for a over center PTO disk clutch for my Lister Petter LT1 build 30 diesel, counter clockwise rotation hence posting in the marine section. The bell housing measured out to SAE #6 (11.25 inch) 8 bolt. The flywheel is were I run into trouble, I have a blank 1 inch PTO input shaft, 3 bolt pattern awaiting to be broached and stubbed for such a clutch. Some vague information i can find is for the Lister Petter ST or TR marine engines with no real specs to use as a reference. Rockford. Wichita. Attached is a photo of the Bell housing end of the engine. Any information will be greatly appreciated. Jesse |
Sponsored Links |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | F o r u m | Replies | Last Post |
Rockford Engine Works, Rockford, Illinois | Denis Rouleau | Antique Gas Engine Discussion | 16 | 04-05-2018 09:20:10 AM |
VH4D Rockford Clutch | Nevr-Enuf-Stuf | Wisconsin Engines | 3 | 07-03-2016 11:10:09 PM |
Boring a Rockford | Matt Montague | Antique Gas Engine Discussion | 7 | 12-05-2013 08:47:47 AM |
New Rockford ND show | Dan Donaldson | Steam Stationary Engines, Traction Engines, Steam Boats | 55 | 09-14-2011 04:13:48 PM |
6hp rockford questions | mike in ct | Antique Gas Engine Discussion | 6 | 02-22-2008 10:58:19 AM |