![]() |
|
|
Antique Autos and Trucks All about finding and fixing old car or truck engines and vintage vehicles. |
![]() |
1948 IHC KB1 214 grdthis thread has 14 replies and has been viewed 3858 times
|
![]() |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
When needing parts for old trucks,
Like king pins,engine parts and a batch more Phone Garry in edmonton 1 780 433 1425 Sundown |
The Following User Says Thank You to sundown For This Post:
|
||
Sponsored Links |
#12
|
|||
|
|||
![]()
I am new to this forum, and hope I came to the right place. Hi all, I have a 1947 International Harvester Green Diamond 214 6 cylinder inline engine. and have it all put back together and need to know the torque sequence/order on the head bolts. I was told to torque the head bolts at 65 foot pounds hot. Any replies would be very much appreciated. Thanks again.
|
#13
|
||||
|
||||
![]()
Torque sequences don't vary much from other engines of similar configuration eg; 4, 6 or 8
Regardless of the number of cylinders always start at the center and gradually work your way to the ends tightening across the head as you move toward the ends preferably in three stages. Snug, tighten and torque. It's a very good idea to check torque again in an hour or two after the gasket has had a chance to settle in.
__________________
http://www.youtube.com/cahartley7 |
The Following User Says Thank You to Craig A For This Post:
|
||
#14
|
|||
|
|||
![]()
Torque them in a minimum of 3 steps and the difference between each step should be less than the step before. Then as Craig said retorque it. More details tomorrow.
|
#15
|
|||
|
|||
![]()
I looking for a set of main bearings for my 214. -.010 or -.020.
Can anyone help. Travelall doesn't have them. Thank you. |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | F o r u m | Replies | Last Post |
1948 I H Cub | David Scott | Antique Farm Tractors | 4 | 06-01-2012 09:19:10 AM |
My 1948 72 Twin | Kammer0072000 | Maytag Engine Collectibles | 7 | 10-12-2010 09:34:24 PM |
1948 Alf V-12 | Andrew Mackey | Antique Autos and Trucks | 0 | 03-22-2008 11:08:30 PM |
1948 I H Cub | David Scott | Antique Farm Tractors | 0 | 07-17-2006 09:18:44 PM |