• If you like antique engines, vintage tractors or old iron, please register and join us. When registering, please provide your CITY and STATE as your location!

Scale Models 1/4, 1/3, 1/2, ect

Nick Severson

Subscriber
Last Subscription Date
12/24/2019
My 1" Case belted to a burr mill. Would like to find a smaller table-top mill and swap the hand crank out for a pulley. Would make a fun display at the shows.

 

Colin Farquhar

Subscriber
Last Subscription Date
07/09/2019
Looking at those photos that were just posted-was it common for the Terning 1/4 scale engine to only have the geared pump, or am I just not seeing an injector that's well hidden?
 

Nick Severson

Subscriber
Last Subscription Date
12/24/2019
I have been told by another collector that the above Avery had holes in the boiler and tubes, so not feeling so bad about missing out on it now...

Still would like to find something a little bigger, but had some fun with my 1" today :D

 

Jeff Searson

Registered
Looking for some help or direction... I am in the process of building a model Sawyer-Massey steam engine and am in need of a 6 spoke flywheel, 12” diameter and 3” wide. Does anyone know where I could purchase one? Any help/suggestions would be appreciated. Thank you.
 
Top